Sales to carry out theRepair of water pipesThe Commission has already adopted a proposal for a regulation on theOther, of a width of >= 600 mmImproved in polyurethane resin with good adhesion to materials such as iron, steel, copper, brass, plastic, wood, rubber, silicone, PVC, polyethylene, fibro cement, glass, etc.

Repair of pipes without works

Stopfixing pipesand to perform plumbing repairs with the leak-repair pad, follow these steps:

1. Locate the leakage point in the pipe or pipe and disconnect the pressure from the grid.
2. It is advisable to lighten the surface around the leak to get a better adhesion.
3. With the gloves on (included in the set), activate the dough by hand-molding it for a few minutes, until it reaches a high temperature and gives off a strong smell.
4. Inside the aluminum envelope is the bandage, bag and dip it in water for a few seconds.
5. Wrap the bandage around the pipe or pipe to be repaired, while simultaneously tightening and applying pressure on it.
6. Once the bandage is rolled, pressure on the leak must be continued to prevent bubbles from appearing.

In about 30-40 minutes, the bandage will dry and become hard wrapping the pipe.

If there is a step (different diameters) at the repair point, the smaller diameter shall be increased using a bandage until it is cut into the larger diameter.

Technical characteristics of the leak-repair bandage

• It's not toxic, it's not flammable.
• It's not smelly.
• The following shall be added to the list of the following:²The following is the list of the products used:
• The following shall be added to the list of the following:²The following conditions shall apply:
• Temperature resistance: continuous services up to 150°C. Intermittently up to 250°C.
• Pressure resistance up to 10 kgs/cm²with a thickness of 10 mm.
• Up to 30 kgs/cm²with a thickness of 25 mm.
• Hardness: 82 SHORE D according to ASTM D2240.
• Working time: 3-5 min.
• Drying time: 30 minutes at 20 °C.