Mita-Teknik SIEK-UV1 PULLSWITCH W/WIRE, 7602520
Tweet
Follow @ADJDiTec
.
Če želite cenovno ponudbo za ta izdelek, joj lahko zahtevate s klikom na spodnji gumb.
Zahtevaj cenovnike.
Pull switch for detection of twisted cables. Complete set delivered with wire and stop ball. Part of the safety chain. The SIEK-UV1 Pull Switch is used for limiting the number of times the cables are twisted in a wind turbine. Usually the pull switch is mounted as an extra detection. Normally the software counts the number of CW/CCW via an inductive sensor, if the number is higher than x the cable will be untwisted. If this measurement fails the pull switch is activated and it signals that the wind turbine must be stopped. The auxiliary switches are of a positive opening type, thus suitable for safety functions.The pull switch is often a part of the wind turbine safety chain. Materials and components are wear resistant and protect the equipment against water and dust.
Podobni izdelki
-
PRIKAZOVATI
PODROBNOSTI
2CDS251103R0984 S201-C0,5NA circuit breaker
-
PRIKAZOVATI
PODROBNOSTI
HEAT EXCHANGER L385 W200 H65
-
PRIKAZOVATI
PODROBNOSTI
GJD8270420R0113 contactor EK 370-40-22 230V-240V 50HZ
-
PRIKAZOVATI
PODROBNOSTI
SMA Sunny Tripower X 20.0
-
PRIKAZOVATI
PODROBNOSTI
Blade block f hydr. pitch 2.3MW Mk3
-
PRIKAZOVATI
PODROBNOSTI
THERMOSTAT for ABB converter