Electrovalves of NC servo-assisted opening Brass

This type of electrovalve has been studied to meet the most varied requirements in the automation of fluid control systems.

The body and lid are of stamped brass. The guide tube, magnetic cores and springs, in contact with the fluid are made of stainless steel. The closing joints can be of NBR, FKM or EPDM.

The closure is fully stationary from 0 bar to maximum working pressure. Another peculiarity is the design of its closure system, very reliable and safe, since the fluid pressures on both sides of the membrane are always balanced.

The following information is provided by the Commission:

Order: Electric at 230 V (available 24-48-110 VAC and 12-24-110 Vdc upon request from us)

Function: Usually closed.

The following information is provided for in the Annex to Implementing Regulation (EU) 2015/2449.

The liquid viscosity:5E 38 cST maximum.

IP 65 protection with DIN connector.

Valve body: Brass stamped with nickel.

Closing board: NBR (nitride)

Guide and Core: Stainless steel.

Resort: Stainless steel.

The Commission shall adopt implementing acts in accordance with Article 21 of this Regulation.The maximum working pressure and the valve passing hole are not dependent on the coil power. These types of valves can operate at relatively high pressures with passing holes higher than direct control electrovalves.

The Commission shall adopt implementing acts.The following:
NC Normally Closed: Without electrical voltage the electrovalve is closed and opened when electrically connected.

The Commission has not yet adopted a proposal for a regulation.

Other, not further worked than hot-rolled 3/8′′- DN10

Other, including: 1/2′′ DN12

Other, not further worked than hot-rolled 3/4′′ DN20

Other, not further worked than hot-rolled 1′′ DN25

Other, not further worked than cutting 1 1/4′′ DN32

Other, not further worked than cutting 1 1/2′′ DN40

Other, not further worked than hot-rolledOther, not further worked than cutting