Smile Tina Emergency Stop Button by ABB

The Smile Tina emergency stop button from ABB is very easy to install, especially in aluminum extrusions. There are three different versions available, with one or two M12 connections or cable. Two M12 connectors are used to allow the connection of emergency stop buttons in series, which is often used with dynamic safety circuits that meet Category 4 safety.

At the top of the Smile Tina emergency stop unit, an LED indicates the current status according to the dynamic system. The Smile Tina from ABB has been designed for use in safety circuits in accordance with EN 60204-1.

LED Indication

Technical Specifications

• Material of the housing: polyamide PA66, Macromelt, polybutyleneterephthalate PBT, polypropylene PP, UL 94 V0
• Operating temperature range: -10 → +55 °C
• IP65 protection rating
• Time delay t (input/output): t < 70 μs
• Meets Category 4 safety
• Actuator force (emergency stop button): 22 + /- 4N
• Actuator travel: ∼ 4 mm to lock
• Connector: 5-pole male M12
• Mechanical service life: > 50,000 operations
• Impact resistance (sinusoidal half wave): Max. 150 m/s2, pulse width 11 ms, 3 axes (according to EN IEC 60068-2-27)
• Vibration resistance (sinusoidal half wave): Max. 50 m/s2 at 10 Hz, 10 cycles, 3 axes (according to EN IEC 60068-2-6)

Certifications

• CE, TUV

Standards

• EN ISO 12100-1, EN ISO 12100-2, EN 60204-1, EN 954-1, EN ISO 13849-1, EN 62061, IEC 60947-5-1

Emergency Stop Push Button