XPS MCWIN, Configuration Software

30 certified safety functions are available with this software and they are easily assignable to the safety outputs. The safety functions have multiple combination possibilities and various starting conditions. The safety functions are certified in accordance with EN 954-1/ISO 13849-1 and IEC 61508.

All 8 safety outputs are suitable for use in safety related parts of control systems conforming to category 4 of EN 954-1/ISO 13849-1 and each output can disconnect one of its safety circuits.

Main Safety Functions:

• Emergency stop monitoring, with or without time delay, 1 or 2-channel wiring
• Two-hand control (type III-C conforming to EN 574-1)
• Guard monitoring with 1 or 2 limit switches, with or without locking
• Guard monitoring for injection presses and blowing machines
• Coded magnetic switch monitoring
• Safety mat monitoring
• Light curtain monitoring, solid-state and relay output types
• Zero speed detection
• Dynamic monitoring of hydraulic valves on linear and eccentric presses
• Monitoring safety stop at top dead centre on eccentric press
• Safety time delays
• "Muting" function for light curtains
• Enabling switch monitoring, 2 or 3 contact
• Logic OR function
• Foot switch monitoring
• Chain shaft breakage monitoring
• Hydraulic and eccentric press monitoring
• Position selector

Note

To connect XPS-MC to a PC for programming and diagnostic purposes:

• Laptop PC with 9 pin serial port: use 382-2645 and 544-490
• Laptop PC with USB port: use 464-962 and 218-080

Safety Controller