SICK 6013186 VTE18-3F8712

Name: ADJ DiTec Málaga S.L.
Address: Calle Marie Curie 9, BLQ 4, ESC 4A, Málaga, Málaga, 29590, ES
Telephone: +34 951 152 505

The following is a list of the characteristics:

Type of device	Other, of a kind used for the manufacture of goods
The principle of the sensor/detection	The following information is provided by the Commission:
The following is the list of the dimensions (An x Al x Pr)	Other, of a width of not more than 30 mm
The shape of the housing (light output)	Other, of a kind used for the manufacture of goods
Box length	Other, of a width of not more than 6 mm
The size of the mesh (carcase)	M18 x 1
Optical axis	Axial
The maximum detection range.	10 mm ... 800 mm^{1) The following:}
Distance of switching	10 mm ... 700 mm
Linear scanner	Approximately 2.8°
Type of light	Infrared light
Light source	LEDs^{2) The following:}
The size of the spot (separation)	Ø 40 mm (800 mm)
The following shall be added to the list of the following:	Approximately 2.8°
Adjustment	Power meter, 270° (distance of switching)

^{1) The following:}Material with a 90% reflectance (over the standard white according to DIN 5033).
^{2) The following:}Average service life of 100,000 h with T_UIt's 25 degrees.

Mechanical and electronic equipment

Power supply voltage	10 V DC ... 30 V DC^{1) The following:}
The following is a list of the types of rolling stock:	± 10%^{2) The following:}
Electricity consumption	30 mA^{3) The following:}
Switched output	PNP
Mode of switching	Switch on clear
The following shall be added:_Max.	Other, of a kind used for the manufacture of goods
Response time	Other, of a kind used for the manufacture of goods^{4) The following:}
Frequency of switching	250 Hz^{5) The following:}
Type of connection	3 threaded cable, 2 m^{6) The following:}
Wire material	Other, of a kind used for the manufacture of goods
The driver section	0,14 mm2
The diameter of the cable	Ø 3.1 mm
Circuit protection	A^{7) The following:} B. Other⁸⁾ C. Other⁹⁾ D¹⁰⁾
Protection class	The Commission shall adopt implementing acts.
Weight	100 g
Material of the housing	Plastic, PBT/PC
Optical elements	Plastic, PMMA
Degree of protection	Other, not further worked than cutting
Operating at room temperature	The following conditions shall apply:
The following information is provided:	The following information shall be provided:

^{1) The following:}Limit values.
^{2) The following:}U tolerances must not be exceeded excessively or by default_V- I 'm not .
^{3) The following:}No charge.
^{4) The following:}Duration of the signal with ohmic load.
^{5) The following:}With a clear/dark ratio of 1:1.
^{6) The following:}Do not deform the cable below 0 °C.
^{7) The following:}A = U connections_VProtected against reverse polarization.
⁸⁾B = Input and exit protected against incorrect polarization.
⁹⁾C = Suppression of parasitic impulses.
¹⁰⁾D = Overcurrent and short-circuit proof outputs.