Medidor de torque PCE-DFG N 100TW
- Code / Model:
- Manufacturer: PCE Instruments
- Department:
- Category of products:
- Sub-category: Instruments and equipment
- You've seen it before.: 1
Torque meter up to 100 Nm / External torque sensor 1/2" square inside /
Graphics display / Peak function / Maximum measurement rate 1600 Hz / Software included
Graphics display / Peak function / Maximum measurement rate 1600 Hz / Software included
The torque meter consists of a handheld device and an external torque sensor. The torque sensor is connected to the torque meter via a 1.5 m cable, allowing installation on a test machine or direct assembly on a test table.
We send the factory-adjusted torque meter, which allows the user to make measurements and receive it. Optionally you can request an ISO calibration certificate for this torque meter. This certification is a comparison between nominal and real values. For this, a traceable
The torque meter sensor's input is 1/2" square inside. The sensor allows measuring in both directions: left and right. With a measuring ratio of 1600 Hz it can accurately measure the maximum torque time (Peak). The torque meter screen shows the firing time separately
We send the factory-adjusted torque meter, which allows the user to make measurements and receive it. Optionally you can request an ISO calibration certificate for this torque meter. This certification is a comparison between nominal and real values. For this, a traceable
The torque meter sensor's input is 1/2" square inside. The sensor allows measuring in both directions: left and right. With a measuring ratio of 1600 Hz it can accurately measure the maximum torque time (Peak). The torque meter screen shows the firing time separately
- Torque measurement: left and right
- Measurement rate: 1600 Hz
- Accuracy: 0.5 percent F.S.
- The PEAK / Hold function
- Graphic screen
- Software
- Power by grid and accumulator
- Measurement rate: 1600 Hz
- Accuracy: 0.5 percent F.S.
- The PEAK / Hold function
- Graphic screen
- Software
- Power by grid and accumulator
| Rate | 0 ... 100 Nm |
| Resolution adopted by the Council | 0,1 Nm |
| Accuracy | ± 0,5% F.S. |
| Units | The following is the list of the countries of the European Union: |
| It takes torque sensor | 1/2" (12.5 x 12,5 mm) square inside |
| Torque measurement | Left / right |
| Measurement quota | 6 ... 1600 Hz |
| Screen | TFT display of 2,8" |
| Alarm mode | Value within and value outside range |
| Memory | 100 series, with 8000 values per series |
| Interface | USB or other |
| Food | The battery is equipped with a battery pack of at least 6 V/ 1600 mAh |
| Operating time | About 10 hours. |
| Source of power | 12 V / 1 A |
| The following shall be added to the list: | 12 V / 50 mA |
| Protection | Other, not further worked than hot-rolled |
| Operating and storage conditions | -10 ... +50 °C 5 ... 95% H.r., not condensed |
| Cable length | About five feet. |
| Dimension | The following information is provided for in the Annex to Regulation (EU) No 1303/2013. Hand equipment: 200 x 97 x 42 mm |
| Weight | Other materials of heading 83.0 Hand equipment: 540 g |
