Medidor de automoción PCE-CT 25FN
- Code / Model:
- Manufacturer: PCE Instruments
- Department:
- Category of products:
- Sub-category: Instruments and equipment
- You've seen it before.: 1
Automatic gauge for measuring layer thickness easy to handle with one hand /
Indication of MIN/MAX and MEAN values / Indication of battery status /
Different units / Automatic disconnection / Small and compact design /
For measuring on ferrous (Fe) and non-ferrous (NFe) metals
Indication of MIN/MAX and MEAN values / Indication of battery status /
Different units / Automatic disconnection / Small and compact design /
For measuring on ferrous (Fe) and non-ferrous (NFe) metals
The automotive gauge is used to quickly and accurately measure the thickness of coating in metals. Compared to other devices, it is not necessary to indicate to this automotive gauge whether the base is a ferrous or non-ferrous metal, the equipment automatically recogni
The car meter can display values on the car meter screen in μm, mm and mils. In addition to measuring the coating thickness, the car meter can indicate the maximum, minimum and average value of a series of measurements.
The car meter can display values on the car meter screen in μm, mm and mils. In addition to measuring the coating thickness, the car meter can indicate the maximum, minimum and average value of a series of measurements.
- Small and compact design
- Rapid measurement rate
- Includes calibration standards
- Selection of different units
- Allows continuous measurements
- I drive comfortably with one hand
- Rapid measurement rate
- Includes calibration standards
- Selection of different units
- Allows continuous measurements
- I drive comfortably with one hand
| Rate | Other, of a kind used for the manufacture of goods |
| Accuracy | The following table shows the results of the calculation: |
| Resolution adopted by the Council | The following is the list of the products of the product concerned: Other, of a kind used for the manufacture of goods |
| Units | Other, of a kind used for the manufacture of goods |
| Radius of curvature minimum | Convex: 5 mm Other, of a thickness of not more than 10 mm |
| Minimum measuring area | Ø 20 mm |
| Minimum thickness of the substrate | Fe: 0,3 mm NFe: 0,05 mm |
| Measurement quota | Maximum of 2 Hz |
| Food | 1 x 9 V battery |
| Operating conditions | -10 ... +50 °C, 20 ... 90% H.r. without condensation |
| Storage conditions | -10 ... +60 °C, 20 ... 90% H.r. without condensation |
| Dimension | Other, of a width of not more than 300 mm |
| Weight | Approximately 100 g |
| Other, of a kind used for the manufacture of goods | Other, not further worked than hot-rolled |
