Mita-Teknik SIEK-UV1 PULLSWITCH W/WIRE, 7602520
Tweet
Follow @ADJDiTec
.
إذا كنت ترغب في الحصول على عرض أسعار لهذا المنتج، فيرجى الضغط على الزر التالي.
طلب الأسعار
Pull switch for detection of twisted cables. Complete set delivered with wire and stop ball. Part of the safety chain. The SIEK-UV1 Pull Switch is used for limiting the number of times the cables are twisted in a wind turbine. Usually the pull switch is mounted as an extra detection. Normally the software counts the number of CW/CCW via an inductive sensor, if the number is higher than x the cable will be untwisted. If this measurement fails the pull switch is activated and it signals that the wind turbine must be stopped. The auxiliary switches are of a positive opening type, thus suitable for safety functions.The pull switch is often a part of the wind turbine safety chain. Materials and components are wear resistant and protect the equipment against water and dust.
منتجات مماثلة
-
اظهار
تفاصيل
Marathon 550 Aerosol 0,188L, Polyamine Cured Epoxy Coating in 2K Sprayer Jotun
-
اظهار
تفاصيل
Bracket between ladder and bed plate
-
اظهار
تفاصيل
Power supply in:120-230VAC out:24VDC-40A
-
اظهار
تفاصيل
proIR-AVV Nachrüstset Aviation Light Infrared (AVV)
-
اظهار
تفاصيل
Shell Tellus S4 VX 32 hydraulic oil
-
اظهار
تفاصيل
1SDA013697R0001 clamp cover FP S3-S4 3P